SWAN BALLOON ANIMAL

The Swan Balloon Animal; LETS BEGIN!

Step 1:

Start with inflating the balloon leaving about a 4" tail ( about the legnth of from your middle finder to halfway of the palm). Bend the whole balloon into a large circle so that the knot is inside the cirlce halfway (see below)

Step 2:

Twist wear the knot meets the balloon all together.

Step 3:

The balloon should now have two big loops and a long stand poking upwards. Take one of the loops, squeeze and tuck it into the other one (don't worry; the balloon should not pop). You have now made the swan's body.

Step 4:

The head- fold the uninflated part back along the swan's body. While holding the end squeeze the air from the neck around the bend in the balloon. This will make the balloon stay in a bent position creating a curve for the swan's head.

Step 5:

The head is now done; take the neck and push it back so that the knot where the loops are twisted together hold the neck in place.

THERE'S YOU SWAN!

http://www.coolest-kid-birthday-parties.com/balloon-animal-instructions.html

Balloon Sword

Let make a Balloon Sword

Step 1:

Inflate the 260 balloon and tie the knot.

Step 2:

Make a bubble on the side where the knot is located. This bubble is going to be the hand of the sword, so make it long enough to fit the persons hand you are making the balloon for.

Step 3:

Make two same sized balloons. Twist them with the first balloon made. See Step 4.

Step 4:

All 3 balloons are made and twisted together. Now fix the ballons so that the firts balloon (the handle) sticks downward, and the other two balloons are out to the side to make the sword.

ENJOY!

Standard Dog Balloon Animal

Follow these simple instructions and you are sure to learn how to make a standard balloon animal.

Steps

Step 1:

Inflate a 260 balloon and leave about 4inches left un-inflated (or the lenght from the tip of your middle finger to about half way your palm).

Step 2:

Take the from the knotted side and made a small bubble. This bubble will make the nose.

Step 3:

Make 2 larger bubbles. These bubbles will make the eyes. You now have 3 bubbles, a smaller one and 2 larger ones. Fold the two larger bubbles so that they are side by side and twist with the smaller bubble (the nose) so that they stay in place.

Step 4:

You should now have the face portion of the standard dog. Twist a bubble for the neck portion. This bubble should be about the same length of the eyes, maybe a bit smaller.

Step 5:

Make 2 of the same sized bubbles for the feet. Fold them side by side and twist.

Step 6:

The next bubble you are making is for the body. How ever long you would like the body to be make the bubble.

Step 7:

Make 2 of the same sized bubbles that you made for the front feet (step 5) for the next 2 bubbles. Put them side by side and twist to make them stay together.

Step 8:

You now have the standard dog; you can push a little bit of air into the tail if you like.